Measure the length and width of your cargo space at the top of the bed, and choose a net that is slightly larger than those dimensions. A net that fits exactly is barely possible to pull tight and leaves gaps when you fasten it.
Allow roughly 10 to 20 centimeters extra all around, so you can pull the net properly over the edge and secure it. If your load has a bulge, such as a pile of branches or a stack of sheet material, allow even more space. A net must cover the load completely and not just the top of the bed.
If you use a trailer with high side panels or a cover, measure the outside where the net will go over. If you have several trailers or sometimes borrow one, choose a standard size that fits most of them. A slightly larger net is always easier to use than a net that is too small.
The mesh size determines how your load behaves: the smaller the mesh, the finer the material you can transport without anything falling or blowing through. So always choose the mesh size based on the smallest piece in your load, not the largest.
As a rule of thumb, the mesh should be smaller than the smallest item you are transporting. This is how you can make the choice quickly:
Can’t decide between two sizes? Go for the finer one. A net with small mesh is slightly more expensive and weighs a bit more, but you won’t have to worry about anything falling out of the bed.
The right trailer net depends on what you transport, because garden waste behaves very differently from heavy building materials. So first think about your most common job before you pick a net.
Leaves, grass and clippings are light and blow away easily. A fine-mesh net is the best choice here, ideally one you can pull tight over the load. That way the trailer stays tidy and you leave no trail on the road to the recycling center.
For a trailer net for building materials, you mainly look at strength. Sheet material, insulation and rubble have sharp edges or are heavy, so the net must be sturdy enough not to tear. A woven net made of thick polypropylene or with a reinforced edge lasts longest here. If you are dealing with loose pieces such as tiles or bricks, combine the net with ratchet straps to really secure the load.
For moves and mixed loads, a medium-fine net works best. You can cover a sofa, a few boxes and some loose items with it without constantly having to switch.
You can recognize a good net by its material, a reinforced edge and fastening points that don’t tear out. That’s the difference between a net that lasts one season and one you enjoy for years.
Pay attention to these points before you buy:
If you need ratchet straps or tools to secure everything on your trailer, you will find them in our general range with the other fastening materials and accessories.
Most problems with a cover net don’t come from the net itself, but from the way it is used. With a few simple habits you can avoid the usual mistakes.
After driving a few kilometers, check that everything is still secure. Loads can settle or shift, and then you need to tighten the net again.
If you still don’t know exactly which net suits your trailer after reading this, that’s fine, because together with us you’ll find the answer. We have more than 40,000 items in stock and know the difference between a net for garden waste and a net for heavy building materials.
This is what you can expect from us:
Visit our showroom in Cruquius or contact us. We will help you choose the right trailer net, so your load arrives safely and neatly at its destination.
Place the net centered over the load and first secure the four corners to the trailer’s fastening points. Then finish the sides with the elastic cord or hooks, pulling the net tight downward as you go. For heavy or loose loads, use ratchet straps first and lay the net over them as extra cover.
A net is meant to keep light and loose loads inside the bed, but it doesn’t secure anything. For heavy, stackable or sliding loads such as tiles, sheet material or moving items, you always need ratchet straps or lashing straps. For very fine material such as sand or fine rubble, a tarp or a net with extra-fine mesh is wiser, so nothing blows away.
You can repair small holes by knotting the loose meshes closed with strong nylon or polypropylene cord or by stitching them with a netting needle. Secure a fraying edge with a sturdy finish, for example an extra cord edge or plastic clamps. If the hole becomes larger than a few meshes, or the cord is weathered by the sun, replace the net to prevent it from tearing on the road.
Rinse the net with water after use to remove sand, dirt and garden debris, and let it dry completely before storing it. Store it dry and preferably out of direct sunlight, because even UV-resistant material ages with prolonged exposure. Regularly check the edge and fastening points for wear.
In that case, choose a net with extra room, a good 20 centimeters all around, and distribute the load as evenly as possible to avoid a sharp bulge. You can also first bundle part of the load with ratchet straps, so the net spans a more compact surface. If the net stays slack, use extra fastening points in the middle of the sides.
Yes, with a medium-fine net (approximately 30 mm) made of sturdy polypropylene and a reinforced edge you can get quite far. If you often deal with very fine material or with sharp, heavy construction waste, it pays to buy two nets. That way each net lasts longer and you always have the right net for the job.
Stop at a safe place after the first few kilometers and check whether the net is still tight and whether the load has settled or shifted. Tighten loose parts again and check that no meshes or fastening points have come loose. Repeat this on longer trips after every break.
BMB Techniek B.V.
Crommelinbaan 50
2142 EX Cruquius
Maandag t/m vrijdag: 7.30 – 17.00uur
Zaterdag en zondag: gesloten


© All Right Reserved BMB techniek
Webdesign en bouw door ditisABC